Introduction

Be the envy of onlooking gamers with a shiny new rear bezel on your DSi XL.

Use a push pin to remove the four plastic screw covers on the front bezel. Use a push pin to remove the four plastic screw covers on the front bezel. Use a push pin to remove the four plastic screw covers on the front bezel.
  • Use a push pin to remove the four plastic screw covers on the front bezel.

Add Comment

Remove four Phillips screws securing the front bezel to the rear bezel.
  • Remove four Phillips screws securing the front bezel to the rear bezel.

Add Comment

Using two hands, gently slide the rear bezel upwards. The rear bezel will move only about 2 mm.
  • Using two hands, gently slide the rear bezel upwards.

  • The rear bezel will move only about 2 mm.

Add Comment

Insert a spudger into the gap between the front and rear bezel Rotate the spudger away from the DSi XL, prying the two bezels apart.
  • Insert a spudger into the gap between the front and rear bezel

  • Rotate the spudger away from the DSi XL, prying the two bezels apart.

Add Comment

In the same manner as described above, continue prying along the top edge of the front and rear bezels.
  • In the same manner as described above, continue prying along the top edge of the front and rear bezels.

Add Comment

Separate the rear bezel from the front bezel.
  • Separate the rear bezel from the front bezel.

  • Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.

Add Comment

Use the flat end of a spudger to pry the rear camera off the rear bezel.
  • Use the flat end of a spudger to pry the rear camera off the rear bezel.

  • Remove the rear bezel.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Matt Newsom

Member since: 01/05/2010

30,080 Reputation

71 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 10

All Time: 4,175