Fix Your Stuff Community Store

Ninja Professional Blender BL660 Suction Cups on Base Replacement

Introduction

If the blender is too loud, the suction cups may be damaged or loose. This guide will help you to replace damaged suction cups.

What you need

  1. Ninja Professional Blender BL660 Suction Cups on Base Replacement, Suction Cups on Base: step 1, image 1 of 2 Ninja Professional Blender BL660 Suction Cups on Base Replacement, Suction Cups on Base: step 1, image 2 of 2

    • Using the Phillips #1 screwdriver, remove the 5 screws holding the outer base.

    • Lift the base up to remove it.

    Edit

  2. Ninja Professional Blender BL660 Suction Cups on Base Replacement: step 2, image 1 of 2 Ninja Professional Blender BL660 Suction Cups on Base Replacement: step 2, image 2 of 2

    • Turn the base panel upside down to reveal the suction cup feet.

    Edit

  4. Ninja Professional Blender BL660 Suction Cups on Base Replacement: step 3, image 1 of 1

    • Push the stopper on the suction cup foot through the bottom panel using the iFixit plastic opening tool.

    Edit

  5. Ninja Professional Blender BL660 Suction Cups on Base Replacement: step 4, image 1 of 2 Ninja Professional Blender BL660 Suction Cups on Base Replacement: step 4, image 2 of 2

    • Once stopper has passed through the bottom panel, pull suction cup foot out.

    • Replace suction cup feet as needed.

    • Ninja does not sell suction cup feet. You will need to obtain them from other third party vendors.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

One Comment

Where did you get the suction cups from?

camoramirez - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 8

Past 30 Days: 58

All Time: 4,842