Fix Your Stuff Community Store

Ninja Professional BL610 LED Replacement

Introduction

Use this guide to replace the LED on the circuit board of your device.

What you need

  1. Ninja Professional BL610 LED Replacement, LED: step 1, image 1 of 1

    • Remove six screws (12mm long, 6mm head diameter) from bottom of the blender using a Phillips #2 screwdriver.

    Edit

  2. Ninja Professional BL610 LED Replacement: step 2, image 1 of 1

    • Remove six screws (12mm long, 6mm head diameter) from component housing using Phillips #2 screwdriver.

    Edit

  4. Ninja Professional BL610 LED Replacement: step 3, image 1 of 1

    • Remove five screws from circuit board using Phillips #2 screwdriver.

    Edit

  5. Ninja Professional BL610 LED Replacement: step 4, image 1 of 1

    • Once the screws are removed, lift the circuit board to access the back.

    Edit

  6. Ninja Professional BL610 LED Replacement: step 5, image 1 of 1

    • Locate the LED you wish to replace and note its position on the opposite side of the circuit board.

    Edit

  7. Ninja Professional BL610 LED Replacement: step 6, image 1 of 1

    • Desolder both of the LED leads and remove the LED light. Note the orientation of LED, this is important for replacing the LED. The Replacement LED needs to be soldered in the same orientation.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 1 other contributor

Rosniel Castro

Member since: 09/27/17

482 Reputation

4 Guides authored

Badges: 8

+5 more badges

Team

USF Tampa, Team S14-G3, Boczar Fall 2017 Member of USF Tampa, Team S14-G3, Boczar Fall 2017

USFT-BOCZAR-F17S14G3

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 136