Introduction

If you notice the LED lights on your device are continuously blinking or not working at all, this step-by-step guide will show you how to replace them individually, or all together. For soldering help, follow the How to Solder and Desolder Connections guide.

On the circuit board, locate the LED light you wish to replace. On the bottom of the board, each LED is designated with a small triangle with a line at one tip and a label of LED1, LED2, etc.
  • On the circuit board, locate the LED light you wish to replace.

  • On the bottom of the board, each LED is designated with a small triangle with a line at one tip and a label of LED1, LED2, etc.

Add Comment

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Desolder the two LED leads to the specific bulb.
  • Desolder the two LED leads to the specific bulb.

  • Remove the LED from the circuit board.

  • Properly install the new LED and solder to the board.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 66