Introduction

This will work as a prerequisite guide for all other guides. This helps us break down the device into the main base layer.

Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).
  • Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).

  • Remove the two screws (13 mm long, 6mm head) attaching the Base Cover using a T10 screwdriver.

Add Comment

Carefully remove the second layer from the base. You will not need a screwdriver for this step.
  • Carefully remove the second layer from the base. You will not need a screwdriver for this step.

Add Comment

  • Remove the 2 screws (13mm, 6mm head) connected to the plastic piece holding down the power cord.

  • Then remove the additional 4 screws (13mm, 6mm head) and 2 screws (11mm, 5mm head) securing the base.

  • Carefully lift the base up from the rest of the blender.

Add Comment

  • Remove 4 screws (11mm, 4mm head) connecting the circuit board to the base.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One Comment

Hey Tommee where can I get a circuit board for the ninja bl 773.

Bhesham Sochan - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 17

All Time: 106