Introduction

Replacing the board holding the GPS, DC in and AV out connectors.

Replacement of the electronic card including the GPS connector, DC IN, and AV out.

Parts

No parts required.

  1. Remove the three screw in red
    • Remove the three screw in red

    • Remove the three long screw in orange

    • Remove the screw in yellow

    • Use a little of WD40 if the screw is blocked

  2. Remove the 4 screw in green
    • Remove the 4 screw in green

    • Remove the 2 screw in yellow

    • Slacken the grip side of the cover first

    • Remove the cover wholly.

    • Be carefull with the two flex cables

    • Disconnect the FPC of the back cover

    • Toggle up the black plate to free the flex cable

    • Remove the grip cover by rotating

    • Toggle up the black plate and disconnect the flex cable

    • Toggle up the white plate and disconnect the flex cable

    • Push up the right slide of the connector to free it

    • Push up the bottom of the connector to free it

    • Remove the six screws to free the protection plate

    • Disconnect the white cables

    • Disconnect the microphone Cable

    • Disconnect the speaker cable

    • Remove the two screws to free the PCB

    • Toggle th PCB from Left to Right

    • Disconnect the black cables

    • Remove the two screws

    • Push the IF/SB PCB

    • Unsolder the 3 Wires ( Red, Black, Orange )

Conclusion

To reassemble your device, follow the instructions in reverse order.

Special thanks to these translators:

100%

These translators are helping us fix the world! Want to contribute?
Start translating ›

JOLY

Member since: 03/06/2016

182 Reputation

1 Guide authored

Team

Nexurium - Bastien JOLY Member of Nexurium - Bastien JOLY

Business

1 Member

2 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 1

Past 7 Days: 9

Past 30 Days: 59

All Time: 654