Introduction

Make sure your battery is fully charged and it's the correct model if you have purchased a new battery. The battery should be an EN-EL14a Rechargeable Li-ion Battery or EN-EL14 Rechargeable Li-ion Battery.

Locate the battery compartment on the bottom of the camera directly below the mode dial.
  • Locate the battery compartment on the bottom of the camera directly below the mode dial.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Find the marked arrow on the battery compartment door and firmly push following the arrow's direction to release the latch.
  • Find the marked arrow on the battery compartment door and firmly push following the arrow's direction to release the latch.

I don't think its wise to install a battery when your going to be removing the control board as this could cause a short circuit and the board and or the battery could burn up, you should remove the battery prior to working on the internal parts of the camra

starstrip411 - Reply

Release the latch and allow it to completely open. Insert the battery by following the diagram on the inside of the compartment door.
  • Release the latch and allow it to completely open.

  • Insert the battery by following the diagram on the inside of the compartment door.

  • Close the compartment door and firmly press on the latch until you hear a clicking sound.

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

Irene Huang

Member since: 09/08/2014

397 Reputation

3 Guides authored

Team

CSU Fullerton, Team 1-3, Bruce Fall 2014 Member of CSU Fullerton, Team 1-3, Bruce Fall 2014

CSUF-BRUCE-F14S1G3

6 Members

4 Guides authored

Add Comment

View Statistics:

Past 24 Hours: 8

Past 7 Days: 41

Past 30 Days: 111

All Time: 4,178