Introduction
This guide will show you how to replace the lens to your camera. Refer to LCD screen disassembly for previous steps.
What you need
-
-
Flip the camera upside down (have the side with the buttons facing away from you)
-
Look for the side with the triangle icon with three lines in it, this is the battery door. Add pressure and slide this door slightly until it clicks and pops open.
-
-
-
Once the door clicks, you can open it to reveal the slots holding the memory card and the battery.
-
Focusing on the larger slot, this holds the battery. Push the orange tab away from the slot, this will eject the old battery if one was previously inside.
-
Once this slot is open, you can place the new battery inside.
-
-
-
Remove the two 5 mm screws from the right side panel.
-
Remove the panel from the right side.
-
Remove the single 2.1 mm screw set underneath the panel.
-
-
-
-
Remove the three 2.8 mm screws from the motherboard.
-
Detach the orange tab with the foam on top.
-
-
-
Carefully remove the tab that connects the flash to the motherboard from the port by gently pulling the connector to the right and out of its port.
-