Introduction

This will show you how to open up the camera and replace the camera flash.

Turn the front of the camera toward you.
  • Turn the front of the camera toward you.

On the left side of the camera, use a Phillips #00 Precision Screwdriver to remove the two screws. On the left side of the camera, use a Phillips #00 Precision Screwdriver to remove the two screws. On the left side of the camera, use a Phillips #00 Precision Screwdriver to remove the two screws.
  • On the left side of the camera, use a Phillips #00 Precision Screwdriver to remove the two screws.

On the right side of the camera, remove the first visible screw.
  • On the right side of the camera, remove the first visible screw.

Lift the HDMI and A/V OUT cover to access the hidden screw and remove.
  • Lift the HDMI and A/V OUT cover to access the hidden screw and remove.

Flip the camera upside down and remove the seven marked screws.
  • Flip the camera upside down and remove the seven marked screws.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Remove the two screws hidden underneath the display panel. Remove the two screws hidden underneath the display panel.
  • Remove the two screws hidden underneath the display panel.

Use a plastic opening tool to gently loosen up the sides of the camera. Use a plastic opening tool to gently loosen up the sides of the camera. Use a plastic opening tool to gently loosen up the sides of the camera.
  • Use a plastic opening tool to gently loosen up the sides of the camera.

Carefully open the camera. There are two ribbon cables when opening the camera. Make sure to properly detach them before proceeding. Disassembling Nikon Coolpix P100 Ribbon Cable
Now you have partial access to the camera's motherboard.
  • Now you have partial access to the camera's motherboard.

  • Remove the five indicated screws that are attached to the metal plate.

Remove the hidden top screw that is attached to the metal plate.
  • Remove the hidden top screw that is attached to the metal plate.

Use a plastic opening tool to carefully loosen the metal plate. Remove the panel to access the camera's motherboard. Remove the panel to access the camera's motherboard.
  • Use a plastic opening tool to carefully loosen the metal plate.

  • Remove the panel to access the camera's motherboard.

Now you have access to the camera's motherboard
  • Now you have access to the camera's motherboard

Remove the screw that is located on the left of the view finder.
  • Remove the screw that is located on the left of the view finder.

Carefully detach the two ribbon cables and detach the viewfinder.
  • Carefully detach the two ribbon cables and detach the viewfinder.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nghiem Ngo

Member since: 01/15/2015

243 Reputation

2 Guides authored

Team

USF Tampa, Team 1-1, Tanski Winter 2015 Member of USF Tampa, Team 1-1, Tanski Winter 2015

USFT-TANSKI-W15S1G1

3 Members

4 Guides authored

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 10

All Time: 370