Introduction

This guide will walk you through the necessary steps to remove the back panel of the Nikon Coolpix E5700.

Parts

No parts required.

Use your finger tip to slide the battery release tab toward the battery symbol on the E5700. Open the battery door.
  • Use your finger tip to slide the battery release tab toward the battery symbol on the E5700.

  • Open the battery door.

Add Comment

Pull the battery out of the E5700.
  • Pull the battery out of the E5700.

  • It may be necessary to wiggle the battery while pulling to free it from its pocket in the case.

Add Comment

Turn to the bottom of the camera.
  • Turn to the bottom of the camera.

  • Remove the two Phillips screws located directly below the back monitor

Add Comment

Turn the camera to the side with the memory card slot and open the compartment for the CF card. Remove the top two Phillips screws closest to the back panel.
  • Turn the camera to the side with the memory card slot and open the compartment for the CF card.

  • Remove the top two Phillips screws closest to the back panel.

Add Comment

Turn to the back of the camera.
  • Turn to the back of the camera.

  • Remove the top most Phillips screw on the back panel.

Add Comment

Turn to the last side of the back panel.
  • Turn to the last side of the back panel.

  • Remove the Phillips screw below the eyepiece.

  • Remove the Phillips screw located above the speaker.

Add Comment

Gently begin to remove the back panel. Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.
  • Gently begin to remove the back panel.

    • Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.

Before pulling the panel. You MUST remove first de rubber bumper ( arrond the ocular piece ).

diego - Reply

Now gently unplug the two wires at the bottom of the panel. Now gently unplug the two wires at the bottom of the panel.
  • Now gently unplug the two wires at the bottom of the panel.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Raana

Member since: 04/12/2011

57 Reputation

2 Guides authored

Team

Cal Poly, Team 24-58, Amido Spring 2011 Member of Cal Poly, Team 24-58, Amido Spring 2011

CPSU-AMIDO-S11S24G58

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 1,622