Introduction

Replace the outer casing of your camera if it is damaged.

  1. Remove the screw located near the speaker port using a Phillips 00 screwdriver.
    • Remove the screw located near the speaker port using a Phillips 00 screwdriver.

  2. Turn camera upside down so that the battery compartment is facing you.
    • Turn camera upside down so that the battery compartment is facing you.

    • Remove all four screws from the bottom of the camera with a Phillips 00 screwdriver.

    • Rotate the camera to the opposite side where the A/V outlet is located.

    • Unscrew and remove all four screws with a Phillips 00 screwdriver.

    • Turn the camera so that the Wi-Fi adapter is facing you.

    • Unscrew and remove all four screws with a Phillips 00 screwdriver.

    • Using a plastic opening tool, pry the front casing of the camera.

    • Continue this motion all around the front casing of the camera.

    • Gently pull apart the front casing from the rest of the camera.

    • Using the plastic opening tool pry the back casing of the camera.

    • Orange ribbon is fragile

    • Carefully pull apart the back casing of the camera from the front of the camera without tearing the orange ribbon.

    • Pull down the on the black latch to carefully separate the orange ribbon from the motherboard.

    • Pull apart the orange ribbon and front casing from the rest of the camera.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jessica Brough

Member since: 01/22/2012

120 Reputation

2 Guides authored

Team

Cal Poly, Team 3-28, Amido Winter 2012 Member of Cal Poly, Team 3-28, Amido Winter 2012

CPSU-AMIDO-W12S3G28

4 Members

5 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 961