Introduction

Replace your worn out inner dome daughterboard: which contains Atmel ATMEGA328P, NXP Semiconductors 44501 Near-Field Communications Controller, TXC 8.00 MHz Crystal Quartz Oscillator, YF04E, and the status LED.

  1. Squeeze and pull to pop the cap off of the Nexus Q.
    • Squeeze and pull to pop the cap off of the Nexus Q.

    Add Comment

  2. Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.
    • Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.

    • Once the antenna is disconnected, simply pull it off the outside of the inner dome.

    Why remove the anntenna? what did it do to you?

    rudyt83 - Reply

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • Undo the ZIF connector by prying with a spudger.

    Add Comment

    • Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

    Add Comment

    • Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

    Add Comment

    • Use a spudger to disconnect the daughterboard from the ZIF connector.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alex Thomas

Member since: 01/31/2013

27 Reputation

3 Guides authored

Team

Cal Poly, Team 7-10, Maness Winter 2013 Member of Cal Poly, Team 7-10, Maness Winter 2013

CPSU-MANESS-W13S7G10

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 3

All Time: 791