Introduction

The motherboard is responsible for all major funtions. If major components of your Nest Cam's hardware are malfunctioning or won't function even after troubleshooting, the motherboard may need to be replaced.

Remove the four 6 mm screws from the back panel with the JIS 000 screwdriver.
  • Remove the four 6 mm screws from the back panel with the JIS 000 screwdriver.

  • We suggest designated areas to keep track of all screws.

Add Comment

Open the back panel completely to expose the inside of the Nest Cam.
  • Open the back panel completely to expose the inside of the Nest Cam.

  • Using the tweezers, disconnect the red and black mic cable from the motherboard.

Add Comment

  • Remove the two 4 mm screws with the JIS 000 screwdriver from the center.

  • Disconnect the black Wi-Fi cable from the motherboard with the tweezers.

Add Comment

  • Use a plastic spudger to lift the motherboard slightly up to expose and disconnect the white cable and the yellow/white IR cable with tweezers.

  • Then use the spudger or a finger to lift the motherboard completely up and off.

  • When installing the new motherboard ensure that all wires are reconnected before securing.

Can't find a replaceement motherboard anywhere! Maybe not supposed to be replaced. Bruceontheweb@gmail.com

Bruce Weissman - Reply

Yes where can you find a motherboard for this?

Erica - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Khiry Jones

Member since: 02/29/2016

131 Reputation

1 Guide authored

Team

USF Tampa, Team 1-1, Leahy Spring 2016 Member of USF Tampa, Team 1-1, Leahy Spring 2016

USFT-LEAHY-S16S1G1

7 Members

5 Guides authored

One Comment

where can I get a MoBo for my drop cam?

mikelebp1 - Reply

Add Comment

View Statistics:

Past 24 Hours: 11

Past 7 Days: 48

Past 30 Days: 163

All Time: 15,926