Neato Botvac D8000 Top Face Panel Replacement

Introduction

These step-by-step instructions are provided so you can remove the top cover of the robot. This can be done as a step to remove the wheel or check the wiring.

What you need

Step 1 Top Face Panel

Neato Botvac D8000 Top Face Panel Replacement, Top Face Panel: step 1, image 1 of 1

Grab the rear bumper with both hands on either side.

Edit

Step 2

Firmly pull the bumper forward at a steady pace.
When pulling the bumper forward avoid being too rough because the bumper might break.

Edit

Step 3

Looking from above, remove the two 11mm screws with a Torx T10 screwdriver.

Edit

Step 4

Neato Botvac D8000 Top Face Panel Replacement: step 4, image 3 of 3

Place the robot on its back and remove the six 11mm screws using a Torx T10 screwdriver.

Edit

Step 5

Neato Botvac D8000 Top Face Panel Replacement: step 5, image 3 of 3

Push the clips, located in the back side, inward.
Gently lift up the top cover until you can see the wires. Then gently un-clip all the wires.
When you lift the top cover be careful because the wires are thin and fragile.