Introduction

The bottom cover must be removed prior to replacing or repairing any internal parts of the Mr. Coffee TF6 (hot plate, power cord, and water tubes). In the event that the bottom cover breaks or must be replaced, a replacement cover must by obtained from the manufacturer.

Facing the bottom of the TF6, carefully pull the two rubber feet out with your hands.
  • Facing the bottom of the TF6, carefully pull the two rubber feet out with your hands.

Add Comment

Using a Phillips #1 screwdriver, remove the six 11mm Phillips screws that are holding the bottom cover in place. Using a Phillips #1 screwdriver, remove the six 11mm Phillips screws that are holding the bottom cover in place.
  • Using a Phillips #1 screwdriver, remove the six 11mm Phillips screws that are holding the bottom cover in place.

Add Comment

Gently lift the bottom cover, detaching it from the main body of the TF6.
  • Gently lift the bottom cover, detaching it from the main body of the TF6.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Johnny Romeka

Member since: 01/24/2014

201 Reputation

2 Guides authored

Team

Cal Poly, Team 13-18, Regan Winter 2014 Member of Cal Poly, Team 13-18, Regan Winter 2014

CPSU-REGAN-W14S13G18

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 306