Introduction

This guide outlines how to replace an LCD screen on the Moultrie I45 GameSpy camera

Parts

No parts required.

Image 1/1:
  • Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.

make sure to add commas.

Step 1- remove the 8, 6mm...

Step 2- Using a philips head screwdriver, remove the 6, 4mm screws...

Same thing with step 6. Good page!

Jesica Bartell - Reply

Image 1/1:
  • Remove the butterfly nut from the lid arm.

Add Comment

Image 1/1:
  • Remove the lid-covering.

Add Comment

Image 1/1:
  • Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.

Add Comment

Image 1/1: The two halves are connected by a wire. Pulling too roughly can damage the wires and cause the camera to stop functioning.
  • Gently separate the two halves of the case.

  • The two halves are connected by a wire. Pulling too roughly can damage the wires and cause the camera to stop functioning.

Add Comment

Image 1/1:
  • Using a Philips head screwdriver, remove the 12, 3mm screws from the board.

Add Comment

Image 1/1:
  • Gently remove the circuit board from the face of the camera

Mention the two pieces (black piece) of the LCD screen that you need to remove

Jesica Bartell - Reply

Image 1/1:
  • Remove the LCD screen.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sean Hill

Member since: 01/29/2015

410 Reputation

4 Guides authored

Team

UW Tacoma, Team 3-7, Rose Winter 2015 Member of UW Tacoma, Team 3-7, Rose Winter 2015

UWT-ROSE-W15S3G7

3 Members

4 Guides authored

One Comment

where do you get the new LCD screen?

jeingram - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 12

All Time: 280