Introduction

This guide will describe how to replace the numbered cover buttons in the in-hand partition of the Motorola V60.

Remove battery cover by pushing down release lever at top of phone while prying off cover. Set cover aside. Set cover aside.
  • Remove battery cover by pushing down release lever at top of phone while prying off cover.

  • Set cover aside.

Remove battery by grabbing it near the bottom and lifting out. Remove battery by grabbing it near the bottom and lifting out.
  • Remove battery by grabbing it near the bottom and lifting out.

Unscrew four corner screws with T6 screwdriver. Note: The two top screws are short and silver.  The two bottom screws are black and long.
  • Unscrew four corner screws with T6 screwdriver.

    • Note: The two top screws are short and silver. The two bottom screws are black and long.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift. Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift. Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.
  • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

Starting from left side of phone, remove side buttons and place aside. Note: There should be three buttons. One on each side, and the top. Return phone to starting orientation when done.
  • Starting from left side of phone, remove side buttons and place aside.

    • Note: There should be three buttons. One on each side, and the top.

  • Return phone to starting orientation when done.

Gently remove orange ribbon cable by prying up with spudger. Gently remove orange ribbon cable by prying up with spudger. Gently remove orange ribbon cable by prying up with spudger.
  • Gently remove orange ribbon cable by prying up with spudger.

Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting. Note: Orange ribbon cable is fragile and can be broken.
  • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

    • Note: Orange ribbon cable is fragile and can be broken.

Insert spudger under button board and gently lift, set aside. Insert spudger under button board and gently lift, set aside.
  • Insert spudger under button board and gently lift, set aside.

Life button keypad with spudger and set aside. Life button keypad with spudger and set aside.
  • Life button keypad with spudger and set aside.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

Member since: 01/26/2010

1 Reputation

13 Guides authored

Team

Cal Poly, Team 8-48, Regan Winter 2010 Member of Cal Poly, Team 8-48, Regan Winter 2010

CPSU-REGAN-W10S8G48

4 Members

13 Guides authored

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 2,949