Introduction

To complete this guide you will need a pair of tweezers, a Torx T-6 screw driver, and a wedge to pry with. Before you start be sure to turn off the phone, remove the battery, and find a clean, water free work space.

First, gather your tools. Tweezers T6 Torx driver
  • First, gather your tools.

  • Tweezers

  • T6 Torx driver

  • Plastic opening tool

Add Comment

Take out the battery first!!! Remove the four rubber stoppers around the main screen with tweezers. Remove the four rubber stoppers around the main screen with tweezers.
  • Take out the battery first!!!

  • Remove the four rubber stoppers around the main screen with tweezers.

Add Comment

Use a Torx T-6 Screwdriver to unscrew the 4 screws around the screen. Note that the top screws are black the the bottom screws are silver and that they are different lengths. Note that the top screws are black the the bottom screws are silver and that they are different lengths.
  • Use a Torx T-6 Screwdriver to unscrew the 4 screws around the screen.

  • Note that the top screws are black the the bottom screws are silver and that they are different lengths.

Add Comment

Use a plastic opening tool to separate outer shell from metal interior cover by sliding it along the crease in the case. To easily take off the case close the phone before trying to remove it. To easily take off the case close the phone before trying to remove it.
  • Use a plastic opening tool to separate outer shell from metal interior cover by sliding it along the crease in the case.

  • To easily take off the case close the phone before trying to remove it.

Add Comment

Use a plastic opening tool to separate the inner metal cover from the circuit board. Apply pressure to remove the piece. Use a plastic opening tool to separate the inner metal cover from the circuit board. Apply pressure to remove the piece. Use a plastic opening tool to separate the inner metal cover from the circuit board. Apply pressure to remove the piece.
  • Use a plastic opening tool to separate the inner metal cover from the circuit board. Apply pressure to remove the piece.

Add Comment

Remove rubber covering over the camera. Carefully remove camera and the attached orange ribbon by gently pulling on it. Pull out in the direction of the blue arrow. You can use your fingers or tweezers. Carefully remove camera and the attached orange ribbon by gently pulling on it. Pull out in the direction of the blue arrow. You can use your fingers or tweezers.
  • Remove rubber covering over the camera.

  • Carefully remove camera and the attached orange ribbon by gently pulling on it. Pull out in the direction of the blue arrow. You can use your fingers or tweezers.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brian Avsec

Member since: 02/19/2016

1 Reputation

1 Guide authored

Team

Ohio State, Team 1-1, Garvin Spring 2016 Member of Ohio State, Team 1-1, Garvin Spring 2016

OSU-GARVIN-S16S1G1

4 Members

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 138