Image 1/1:
  • Push down on the black tab located at the top center of the Motorola phone

Add Comment

Image 1/1:
  • Remove the battery by pulling the battery from the top center.

Add Comment

Image 1/1:
  • Remove the four T6 2 mm TX Torx screws

Add Comment

Image 1/2: Image 2/2:
  • Insert the flat end of a plastic opening tool and pry the metal cover up off the phone.

Add Comment

Image 1/2: Image 2/2:
  • Carefully, disconnect the two connectors from their sockets on the motherboard using the flat end of a plastic opening tool.

Add Comment

Image 1/1: De-route the antenna cable by pulling it out.
  • Use a plastic opening tool to pry the antenna cable connectors from its respective socket on the motherboard.

  • De-route the antenna cable by pulling it out.

Add Comment

Image 1/1: The cover is attached by adhesive, so some force may be required.
  • Use a spudger to lift and remove the black plastic screw cover at the bottom of the phone near the speaker

  • The cover is attached by adhesive, so some force may be required.

Add Comment

Image 1/2: The frame is attached by adhesive, so some force may be required Image 2/2: The frame is attached by adhesive, so some force may be required
  • Insert the flat end of a spudger and pry the frame off the phone.

  • The frame is attached by adhesive, so some force may be required

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jorge Trujillo

Member since: 05/19/2011

471 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 2,604