Start off by unpeeling the black display cover over the sensor board.
  • Start off by unpeeling the black display cover over the sensor board.

  • Do not worry, the display board will re-stick when reassembling.

Add Comment

Unscrew the two 3mm Torx Security #6 screws on the edge of the device. Unscrew the two 5mm Torx Security #10 in the middle of the device.
  • Unscrew the two 3mm Torx Security #6 screws on the edge of the device.

  • Unscrew the two 5mm Torx Security #10 in the middle of the device.

Add Comment

Lay the device on its back and unpeel the silicone base. Unscrew the four 5mm Torx Security #10 at base. Unscrew the four 5mm Torx Security #10 at base.
  • Lay the device on its back and unpeel the silicone base.

  • Unscrew the four 5mm Torx Security #10 at base.

Add Comment

Gently remove the metal screen. Gently remove the metal screen.
  • Gently remove the metal screen.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Akshar Patel

Member since: 09/12/2016

228 Reputation

1 Guide authored

Team

CSU Fullerton, Team 2-6, Bruce Fall 2016 Member of CSU Fullerton, Team 2-6, Bruce Fall 2016

CSUF-BRUCE-F16S2G6

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 89