Introduction

If you motor produces little torque or is dead, this guide will show you how to replace the part.

Parts

No parts required.

Place your fingers on the grip to pull out the battery from the device.
  • Place your fingers on the grip to pull out the battery from the device.

Add Comment

Unscrew the device using the driver from the  JIS kit.
  • Unscrew the device using the driver from the JIS kit.

  • Use the part J1 as the Screw diver tip.

  • There are 6 screws and each have a 15 mm Phillips-head.

Add Comment

Pull both ends of the device to separate the motor from the rest of the device.
  • Pull both ends of the device to separate the motor from the rest of the device.

Add Comment

Use the tweezer to disconnect both the  wires connected to the motor. Use the tweezer to disconnect both the  wires connected to the motor. Use the tweezer to disconnect both the  wires connected to the motor.
  • Use the tweezer to disconnect both the wires connected to the motor.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Haseeb Ur Rehman

Member since: 04/21/2017

101 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 5

All Time: 43