Maisto Rock Crawler Rear Axle Replacement

Step 1 Rear Axle

• Flip the R/C truck over.
• To take off the R/C truck top, use the driver and bit PH2 and remove the four 7.7 mm Phillips screws highlighted.
Step 2

• Half way remove the truck top so you can unhinge the antenna from the clips.
• Remove the R/C truck top completely.
Step 3
• Use the Driver and bit J1 to remove the top under-body plate by unscrewing the eight 9.5 mm Phillips screws.
Step 4
• After removing the plate use the driver and bit J1 to unscrew the two 9.5 mm Phillips screws that hold the side circuit board in.
Step 5
• Flip the R/C truck over and remove the four 10 mm bottom under-body plate screws using the driver and bit PH2.
Step 6
• Flip the R/C truck over again.
• Remember which wire is connected at which pin before desoldering.
• Desolder the 2 wires connected from the rear axle to the circuit board.
Step 7
• You can refer to the tire replacement guide to keep salvageable tires from the removed axle.

Author

with 3 other contributors

kevin

Member since: 02/10/16

874 Reputation

6 Guides authored

Badges: 9

• 
• 
• 

+6 more badges

Team

USF Tampa, Team 1-2, Sullivan Spring 2016 Member of USF Tampa, Team 1-2, Sullivan Spring 2016

USFT-SULLIVAN-S16S1G2

3 Members

6 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview