Introduction

If your device won't turn on , you can access or replace the battery by using this guide. Also , make sure you have clean open place to work with. Make sure you have all the tools including the glue, which holds the battery to the panel.

Image 1/1:
  • Flip your device with back panel facing up.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Unscrew four Phillips #0 screws from the back panel.

Add Comment

Image 1/2: Image 2/2:
  • Unscrew two Phillips #0 screws from the back panel.

Add Comment

Image 1/2: Image 2/2:
  • Use a plastic opening tool to pop the right side of the panel.

Add Comment

Image 1/1: Gently lift up the back panel.
  • Lifting the back panel too quickly or forcefully may damage the speaker cable and battery cable, which are still attached underneath.

  • Gently lift up the back panel.

Add Comment

Image 1/3: Unplug the cable for the speaker. Image 2/3: Unplug the cable for the speaker. Image 3/3: Unplug the cable for the speaker.
  • Remove the tape.

  • Unplug the cable for the speaker.

Add Comment

Image 1/3: Tape removal is not necessary. Image 2/3: Tape removal is not necessary. Image 3/3: Tape removal is not necessary.
  • Remove the cable of the battery.

  • Tape removal is not necessary.

Add Comment

Image 1/1:
  • Place the back panel gently on the table.

Add Comment

Image 1/1: Battery is held by glue to the panel.
  • Remove the battery by using the IFIXIT plastic tool.

  • Battery is held by glue to the panel.

  • Remember to glue the new battery with the panel to keep it secure..

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Umar siddique

Member since: 10/25/2016

201 Reputation

2 Guides authored

Team

UMass Dartmouth, Team 1-5, Catania Fall 2016 Member of UMass Dartmouth, Team 1-5, Catania Fall 2016

UMASSD-CATANIA-F16S1G5

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 70