Introduction

Follow this guide to replace the power switch on your device.

Parts

No parts required.

  1. Place the GPS with the screen facing down.
    • Place the GPS with the screen facing down.

  2. Locate the four screws in the back cover of the device. Use a Phillips #0 screwdriver to remove all four 4.2mm Phillips #0 screws.
    • Locate the four screws in the back cover of the device. Use a Phillips #0 screwdriver to remove all four 4.2mm Phillips #0 screws.

    • Locate the screws at the bottom of the device. Use a Phillips #0 screwdriver to remove the two 4.2mm Phillips #0 screws.

    • Insert the black spudger into the crease in the side of the GPS.

    • Move the end of the spudger down to break the seal between the two plastic shells.

    • Continue doing this along each side of the GPS to ensure a smooth removal.

    • Fully separate the two sides of the case.

    • Locate the tape on the battery wires and the tape on the speaker wires. Remove both pieces of tape.

    • Once the back cover has been removed, lift the power switch from the device.

    • This is only a sliding switch, the button to power the device on is inside the unit

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jeremy Johnson

Member since: 03/21/2016

201 Reputation

2 Guides authored

Team

Clemson, Team 7-3, Benson Spring 2016 Member of Clemson, Team 7-3, Benson Spring 2016

CLEM-BENSON-S16S7G3

4 Members

7 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 2

All Time: 77