Skip to main content

Introduction

Use this as a guide to remove or replace the switch on the rear side of the FightPad.

  1. Use tweezers to completely remove the sticker from the rear of controller.
    • Use tweezers to completely remove the sticker from the rear of controller.

  2. Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
    • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

  3. PC Laptop Batteries

    An easy fix for a big power boost.

    Shop Now

    PC Laptop Batteries

    An easy fix for a big power boost.

    Shop Now
  4. Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases. Use the plastic opening tool to pry the two cases apart.
    • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

    • Use the plastic opening tool to pry the two cases apart.

  5. Remove the two rubber side grips. Remove the two rubber side grips.
    • Remove the two rubber side grips.

  6. Locate RS-DP-LS switch. Pull upwards on the switch to remove it.
    • Locate RS-DP-LS switch.

    • Pull upwards on the switch to remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jefferson Hsu

Member since: 09/18/2012

408 Reputation

3 Guides authored

Team

Cal Poly, Team 1-7, Propen Fall 2012 Member of Cal Poly, Team 1-7, Propen Fall 2012

CPSU-PROPEN-F12S1G7

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 1,220