MacBook Pro 15" Unibody Late 2008 and Early 2009 Access Door Replacement

Remove the Access Door from your laptop.

This guide will show you how to remove the Access Door from your laptop.

Edit Step 1 Access Door  ¶ 

Image #1

Edit Step 1 Access Door  ¶ 

  • With the case closed, place the Unibody top-side down on a flat surface.

  • Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.

Edit Step 2  ¶ 

Image #1

Edit Step 2  ¶ 

  • The access door should now be raised enough to lift it up and out of the Unibody.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the MacBook Pro 15" Unibody Late 2008 and Early 2009 device page.

Related Products

Comments Comments are onturn off

The A1286 has no Access Door.!!

I actually can see no sign of the battery!...

aguib, · Reply

Quote from aguib:

The A1286 has no Access Door.!!

I actually can see no sign of the battery!...

I assume you have the newer model, with the built-in battery. It's still removable with tools, but these are the wrong instructions for that model.

lgc90, · Reply

when will there be a guide for the other unibody macbook pro. that does not have an access door?

irishking, · Reply

Is there a manual to show, how disasembly the display, i mean, after step 5, to check the display between lcd and aluminiun back case?

Max

Max, · Reply

On other guides you state the height of the HD that can be supported, e.g. http://www.ifixit.com/Guide/Repair/Insta... , I have read ( but have not confirmed ) that the uni-body MacBook Pro can be fitted with the 750GB and 1TB 12mm drive from Western Digital.

Can you confirm this?

Many thanks in advance.

ahothabeth, · Reply

Quote from SHerwood Ball:

My display and aluminum casing has separated.

I don't know if it just snaps back together or does it need to be glued.

I dropped mine on the carpeted stairs and the display still works.

I'm hoping I can just snap it back together and that no plastic pieces or teeth of the snapping

portion have been broken........

SHerwood Ball, · Reply

When you say "left fan" is this "left when looking at the logic board after turning the computer over and looking it up opening it up" or "left when sitting at the computer keyboard and typing on it"?

thvv, · Reply

We always use left and right in reference to the computer when you're using it.

Andrew Optimus Goldberg,

Directions were great and the worn dc in board was replaced. The hardest part of the procedure is disconnecting the data display cable. A better description of step 21 is to slide the connector parallel to the circuit board towards the outside corner. Reconnecting correctly took several tries.

I used the tip of the spudger to nudge the corners a little at a time to seat the connector.

The ribbon connector for the keyboard has to be inserted all the way before seating the retaining cap. It took me three tries . First try power button did not work second try numbers keys did not work.

Thanks for the directions ...could not have done it with out them!!!

landryd, · Reply

View Statistics:

Past 24 Hours: 0

Past 7 Days: 15

Past 30 Days: 115

All Time: 25,268