Introduction

Use this guide to replace the AirPort board.

  1. Remove the following P5 pentalobe screws securing the lower case to the MacBook Pro:
    • Remove the following P5 pentalobe screws securing the lower case to the MacBook Pro:

      • Eight 3.0 mm

      • Two 2.3 mm

  2. Lifting from the edge nearest the clutch cover, lift the lower case off the MacBook Pro.
    • Lifting from the edge nearest the clutch cover, lift the lower case off the MacBook Pro.

    • Set the lower case aside.

    • Peel back the warning label covering the battery connector.

    • Using the flat end of a spudger, gently pry the battery connector straight up out of its socket on the logic board.

    • Bend the battery cables back and out of the way, ensuring that the battery connector doesn't accidentally make contact with the logic board.

    • Use the tip of a spudger to detach the three antenna connectors up from their sockets on the AirPort board.

    • Remove the single 2.9 mm T5 Torx screw securing the AirPort board to the logic board.

    • Grasp the edges of the board and slide it out from its connector.

    • Lift and remove the AirPort board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 other people completed this guide.

0 Comments

View Statistics:

Past 24 Hours: 7

Past 7 Days: 47

Past 30 Days: 158

All Time: 14,835