Introduction

Prereq only.

Image 1/1:
  • Remove the 7.9 mm T6 Torx screw securing the hard drive tray to the outer case.

Add Comment

Image 1/1:
  • Remove the hard drive tray from the outer case.

With virtually everything removed from the outer case, this is a good time to look toward the front of the case to notice the two locations where the standoffs from the "lower" drive normally fit. You'll want to be aware of this when reinstalling that drive later.

UNSC Jon 117 - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment