Logitech Harmony Smart Keyboard Back Panel

Step 1 Back Panel



• Turn keyboard over to the backside.
Step 2




• Press and slide up on the upper battery latch, using both thumbs.
Step 3
• Remove the two AA batteries and set them aside.
Step 4
• Unscrew all five 4.0 mm screws, using Phillips #1 screwdriver.
Step 5
• Peel off the center sticker to reveal two hidden 4.0 mm screws.
• Unscrew these two screws with a Phillips #1 screwdriver.
Step 6
• Lift both top left and top right rubber stickers halfway, using the sharp end of the plastic spudger.
• Unscrew a total of two 4.0 mm screws, under the rubber stickers, using a Phillips #1 screwdriver.
Step 7
• Unscrew the top center 4.0 mm screw, in the battery compartment, using the Phillips #1 screwdriver.
• Now, you should have a total of ten 4.0 mm screws set aside.
Step 8
• Wedge the flat end of the spudger between the back panel and front panel.
• Slide the flat end of the spudger from right to left to pry the two panels apart.
Step 9
• Separate the back panel from the front panel completely, using both hands.
• A white ribbon flex cable will remain connected to both panels.
• Pull the panels apart slowly and gently, or the white ribbon flex cable may be unsafely removed.

Author

with 4 other contributors

Hayley Nichols

Member since: 09/05/17

525 Reputation

4 Guides authored

Badges: 11

• 
• 
• 

+8 more badges

Team

CSU Fullerton, Team S1-G2, Bruce Fall 2017 Member of CSU Fullerton, Team S1-G2, Bruce Fall 2017

CSUF-BRUCE-F17S1G2

3 Members

10 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview