Introduction

If the battery to the remote is not working properly, follow this guide to replace it.

Make sure the remote control is powered off before starting.
  • Make sure the remote control is powered off before starting.

  • Use the Opening Tool to open the port cover at the bottom of the remote control.

  • Bend the cover back to gain easy access to the screws.

Add Comment

Use the Phillips #0 Screwdriver to    remove the (2) two 6mm screws.
  • Use the Phillips #0 Screwdriver to remove the (2) two 6mm screws.

  • Pull the bottom cover off of the remote control.

Add Comment

  • Use the Phillips #0 Screwdriver to remove the (2) two 6mm screws.

  • There should be a gap on each side to fit the Opening Tool. Use the Opening Tool to open the back cover (Soft Touch cover) using the gap.

Add Comment

  • Use the Opening Tool to lift the battery out of the case.

  • Gently pull the cable out of the socket to unplug the battery.

  • Be careful not to damage any part of the remote when pulling the cable out.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Blake Sanborn

Member since: 09/26/2017

374 Reputation

3 Guides authored

Team

USF Tampa, Team S2-G2, Passmore Fall 2017 Member of USF Tampa, Team S2-G2, Passmore Fall 2017

USFT-PASSMORE-F17S2G2

4 Members

4 Guides authored

One Comment

And where to buy these batteries?

Rene A - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 12

Past 30 Days: 29

All Time: 407