Image 1/2: There may be resistance, do not be afraid to use force. Image 2/2: The tray should then pop open.
  • Insert a paper clip into a small hole on the right side of the faceplate bellow the disc tray.

    • There may be resistance, do not be afraid to use force.

  • The tray should then pop open.

  • Pull out the tray so that it is fully extended.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Use a plastic opening tool to push the three tabs located on the right, left, and bottom side of the outer chassis to loosen the faceplate off.

Add Comment

Image 1/1: Do NOT pull the faceplate all the way off the disc tray, because doing so can cause damage to the faceplate.
  • Pull the faceplate off the chassis.

    • Do NOT pull the faceplate all the way off the disc tray, because doing so can cause damage to the faceplate.

    • There may be resistance, do not be afraid to use force.

Add Comment

Image 1/1:
  • Using the Phillips Head #2 screwdriver, unscrew the two 8.5 mm screws located on the bottom back of the chassis.

Add Comment

Image 1/1:
  • Remove the bottom plate by lifting it off the device.

Add Comment

Image 1/1: Remove the top plate by pulling the sides and lifting the plate off.
  • Turn the device over.

  • Remove the top plate by pulling the sides and lifting the plate off.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Kayla Culpepper

Member since: 03/22/2015

528 Reputation

5 Guides authored

Team

Baylor, Team 5-9, Williams Spring 2015 Member of Baylor, Team 5-9, Williams Spring 2015

BU-WILLIAMS-S15S5G9

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 11

All Time: 213