Introduction

Is your screen too dim, plagued with dead pixels, or just not working at all anymore? Fixing it can be a lot easier than you might think with this screen replacement guide for the Lenovo IdeaPad U310.

Flip the device over so the bottom panel is facing up.
  • Flip the device over so the bottom panel is facing up.

    • Remove the rubber feet by pinching and pulling in an upward motion.

    • The rubber feet are missing from this photo, but will be located within the red markups.

Add Comment

Remove the 4 screws securing the bottom panel to the device.
  • Remove the 4 screws securing the bottom panel to the device.

  • The screws are missing from this device and are not pictured. They will be located under the rubber feet within the red markups.

Add Comment

Place the plastic opening tool between the bottom panel and device. Pry around the device's outer edge until the bottom panel is no longer attached.
  • Place the plastic opening tool between the bottom panel and device.

  • Pry around the device's outer edge until the bottom panel is no longer attached.

  • Lift the bottom panel up and away from device.

Add Comment

Unplug the Battery from the circuit board by carefully prying the connector from its housing. Unplug the Battery from the circuit board by carefully prying the connector from its housing.
  • Unplug the Battery from the circuit board by carefully prying the connector from its housing.

Add Comment

Remove the 5.6 mm Screw with the PH1 screwdriver. Remove the 4.6 mm screws with the PH1 screwdriver.
  • Remove the 5.6 mm Screw with the PH1 screwdriver.

  • Remove the 4.6 mm screws with the PH1 screwdriver.

Add Comment

Lift the strip tape away from the battery, being careful not to completely remove it. Lift the strip tape away from the battery, being careful not to completely remove it.
  • Lift the strip tape away from the battery, being careful not to completely remove it.

Add Comment

Remove the battery by lifting up and away from device.
  • Remove the battery by lifting up and away from device.

Add Comment

Insert opening tool between the frame and the back panel of the screen.
  • Insert opening tool between the frame and the back panel of the screen.

Add Comment

Work your way around the frame until every connection is loose.
  • Work your way around the frame until every connection is loose.

Add Comment

Lift the screen up and away from the device.
  • Lift the screen up and away from the device.

  • Do not tamper with the tape on the bottom of the screen labeled "Don't touch".

Add Comment

Remove the 1.9 mm screws using the PH0 screwdriver. These screws are very short and small, keep track of them.
  • Remove the 1.9 mm screws using the PH0 screwdriver.

  • These screws are very short and small, keep track of them.

Add Comment

Once the four screws are removed, gently rest the screen facedown on the keyboard. Once the four screws are removed, gently rest the screen facedown on the keyboard.
  • Once the four screws are removed, gently rest the screen facedown on the keyboard.

Add Comment

Peel back the white tape, revealing the power connection. Peel back the white tape, revealing the power connection.
  • Peel back the white tape, revealing the power connection.

Add Comment

Unplug the connector, pulling it by the white tape. Unplug the connector, pulling it by the white tape.
  • Unplug the connector, pulling it by the white tape.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 42

Past 30 Days: 149

All Time: 1,286