Introduction

If you need more storage space, or a boost in speed, this guide will help you to replace the RAM in your IdeaPad.

Image 1/1: Flip the device over so the bottom panel is facing up.
  • Make sure device is turned off and disconnected from any power source before proceeding.

  • Flip the device over so the bottom panel is facing up.

  • Remove the rubber feet by pinching and pulling in an upward motion.

  • The rubber feet are missing from this photo, but will be located within the red markups.

Add Comment

Image 1/1: The screws are missing from this device and are not pictured. They will be located under the rubber feet within the red markups.
  • Remove the 4 screws securing the bottom panel to the device.

  • The screws are missing from this device and are not pictured. They will be located under the rubber feet within the red markups.

Add Comment

Image 1/2: Pry around the device's outer edge until the bottom panel is no longer attached. Image 2/2: Lift the bottom panel up and away from device.
  • Place the plastic opening tool between the bottom panel and device.

  • Pry around the device's outer edge until the bottom panel is no longer attached.

  • Lift the bottom panel up and away from device.

Add Comment

Image 1/1:
  • Pry the RAM's two holding clips in an outward motion.

Add Comment

Image 1/2: Image 2/2:
  • Continue to pry open the clips, and slip the RAM from its housing.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 7

Past 30 Days: 37

All Time: 326