Introduction
When connecting to the internet, the computer should see the available wifi signals. If it cannot find any signals, the wireless card could be the problem.
What you need
-
-
Push the left switch (labeled 1) to the left to show red underneath. This will unlock battery.
-
Push the right switch (labeled 2) to the right. This will eject battery.
-
-
-
Remove the three 6mm Phillips #0 screws holding the back access panel on.
-
-
-
-
Disconnect the two plugs on the wireless card by pulling them up with a small tool.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Team
Central Washington University, Team S1-G7, Pengilly Fall 2018 Member of Central Washington University, Team S1-G7, Pengilly Fall 2018
CWU-PENGILLY-F18S1G7
3 Members
6 Guides authored
