Introduction

Replace damaged keypad.

Parts

No parts required.

Lay the phone face down with the screen in palm of hand.
  • Lay the phone face down with the screen in palm of hand.

  • Slide the grey button towards the top of the phone.

Add Comment

While the button is slid up grab the battery on the sides and pull up with the bottom remaining in place.
  • While the button is slid up grab the battery on the sides and pull up with the bottom remaining in place.

  • Pull the battery up vertically to completely remove from phone.

Add Comment

Locate four screws underneath of the battery.
  • Locate four screws underneath of the battery.

  • Remove screws by turning counter clockwise with screwdriver until they pop out.

Add Comment

Place fingers on bottom of phone near charger adapter and pry back half of bottom apart.
  • Place fingers on bottom of phone near charger adapter and pry back half of bottom apart.

  • Note: There will be a significant amount of resistance.

Add Comment

Lift up logic board without completely removing from phone.
  • Lift up logic board without completely removing from phone.

  • Remove entire keypad from beneath the logic board.

Add Comment

Insert replacement keypad with buttons aligned in proper holes.
  • Insert replacement keypad with buttons aligned in proper holes.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nichole Shaw

Member since: 04/13/2010

1 Reputation

7 Guides authored

Team

Cal Poly, Team 18-75, Johann Spring 2010 Member of Cal Poly, Team 18-75, Johann Spring 2010

CPSU-JOHANN-S10S18G75

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 991