Introduction

A few steps to remove the back of the phone.

Image 1/2: Image 2/2:
  • Turn the phone on its back.

Add Comment

Image 1/2: Remove the battery cover by pushing upward with your thumb. Image 2/2: Remove the battery cover by pushing upward with your thumb.
  • Orient the phone as shown.

  • Remove the battery cover by pushing upward with your thumb.

Add Comment

Image 1/2: Image 2/2:
  • Place your fingernail at the top of the battery and pry the battery out towards you.

Add Comment

Image 1/1:
  • Orient the phone as shown with the battery already removed.

Add Comment

Image 1/3: Use a Phillips #00 screwdriver to remove the 5 screws as shown here. Image 2/3: Use a Phillips #00 screwdriver to remove the 5 screws as shown here. Image 3/3: Use a Phillips #00 screwdriver to remove the 5 screws as shown here.
  • Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards.

  • Use a Phillips #00 screwdriver to remove the 5 screws as shown here.

Add Comment

Image 1/3: Run the tool around the perimeter of the entire phone. Image 2/3: Run the tool around the perimeter of the entire phone. Image 3/3: Run the tool around the perimeter of the entire phone.
  • Place an iPod opener tool in the seam above the antenna.

  • Run the tool around the perimeter of the entire phone.

Add Comment

Image 1/1:
  • Check to see that your device looks like the attached photo.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Douglas Blaalid

Member since: 01/13/2010

261 Reputation

8 Guides authored

Team

Cal Poly, Team 4-13, Forte Winter 2010 Member of Cal Poly, Team 4-13, Forte Winter 2010

CPSU-FORTE-W10S4G13

5 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 3,075