Introduction

It will allow users to remove and install a new camera if their current one is broken. In cases where the currently installed camera is cloudy or needs cleaning, this guide will be helpful in doing so without effecting other parts of the device.

Image 1/2: A metal spudger can easily damage your device. A plastic opening tool is always the only option. Image 2/2: A metal spudger can easily damage your device. A plastic opening tool is always the only option.
  • Slide a plastic spudger, or guitar pick, between the back and front panel at the bottom .

  • A metal spudger can easily damage your device. A plastic opening tool is always the only option.

Add Comment

Image 1/2: Image 2/2:
  • Carefully pop the back panel off and place it to the side.

Add Comment

Image 1/2: Image 2/2:
  • Use the thumb tab to remove the battery.

Add Comment

Image 1/1:
  • Remove the eight 4mm screws along the side of the mid panel using the Phillips #000 screwdriver head.

Add Comment

Image 1/2: Place the mid panel to the side. Image 2/2: Place the mid panel to the side.
  • Slide a plastic opening tool between the mid-panel and front panel to remove the middle panel.

  • Place the mid panel to the side.

Add Comment

Image 1/2: The camera will be completely free at this point. Image 2/2: The camera will be completely free at this point.
  • Detach the back camera from the back of the mid panel using a plastic opening tool, and remove it.

  • The camera will be completely free at this point.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mohammed Samin

Member since: 02/09/2016

106 Reputation

1 Guide authored

Team

USF Tampa, Team 4-6, Lacy Spring 2016 Member of USF Tampa, Team 4-6, Lacy Spring 2016

USFT-LACY-S16S4G6

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 8

All Time: 181