Turn off the cell phone and place face down on a flat surface.
  • Turn off the cell phone and place face down on a flat surface.

Add Comment

While sliding the gray tab up, lift battery up and away from the cell phone. While sliding the gray tab up, lift battery up and away from the cell phone.
  • While sliding the gray tab up, lift battery up and away from the cell phone.

Add Comment

Remove battery and set aside. Remove battery and set aside. Remove battery and set aside.
  • Remove battery and set aside.

Add Comment

Use a Spudger to remove the two front plastic covers to reveal screws. Use a Spudger to remove the two front plastic covers to reveal screws.
  • Use a Spudger to remove the two front plastic covers to reveal screws.

Add Comment

Remove two screws using a Torx T6 screwdriver.
  • Remove two screws using a Torx T6 screwdriver.

Add Comment

Pry off screen front cover with a Small Flathead Screwdriver. Pry off screen front cover with a Small Flathead Screwdriver.
  • Pry off screen front cover with a Small Flathead Screwdriver.

Add Comment

Insert Small Flathead Screwdriver into the hinge and separate hinge connection.
  • Insert Small Flathead Screwdriver into the hinge and separate hinge connection.

Add Comment

Pry off the speaker which is glued on to the front cover using a Small Flathead Screwdriver.
  • Pry off the speaker which is glued on to the front cover using a Small Flathead Screwdriver.

Add Comment

Remove remaining portion of the front case from the flexible circuit board.
  • Remove remaining portion of the front case from the flexible circuit board.

  • Do not attempt to remove the LCD board at this time, as it is attached to the rear panel assembly.

Add Comment

Unscrew the four screws on the back case using a T6 Torx Screwdriver. Unscrew the four screws on the back case using a T6 Torx Screwdriver.
  • Unscrew the four screws on the back case using a T6 Torx Screwdriver.

Add Comment

Pull the back cover straight off the phone using your thumb and forefinger. Pull the back cover straight off the phone using your thumb and forefinger.
  • Pull the back cover straight off the phone using your thumb and forefinger.

Add Comment

Pry off circuit board with a flathead screwdriver.
  • Pry off circuit board with a flathead screwdriver.

Add Comment

Pull out flexible keypad.
  • Pull out flexible keypad.

Add Comment

The phone should now look like the picture to the left.
  • The phone should now look like the picture to the left.

Add Comment

Locate and detach the ribbon cable from circuit board. Locate and detach the ribbon cable from circuit board.
  • Locate and detach the ribbon cable from circuit board.

Add Comment

Remove the LCD Screen from the phone case and replace with a new LCD screen. Remove the LCD Screen from the phone case and replace with a new LCD screen.
  • Remove the LCD Screen from the phone case and replace with a new LCD screen.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Nicholas Schmidt

Member since: 10/09/2010

34 Reputation

7 Guides authored

Team

Cal Poly, Team 3-25, Regan Fall 2010 Member of Cal Poly, Team 3-25, Regan Fall 2010

CPSU-REGAN-F10S3G25

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 781