Kurio Touch 4S Power Button Replacement

Make sure to open the back cover easily using the plastic opening tool.

Remove back cover by prying away from the device.

To remove the battery, make sure the four 5mm Phillips screws on each side of your device is open using the Phillips #1 Screwdriver

After you remove your four 5mm Phillips screws, use your plastic opening tool to help you open the plastic cover of your device.

After you remove your four 5mm Philips screws use your plastic opening tool to help you open the plastic cover of your device.

Separate the two halves of your Kurio Touch 4S and lay them besides each other.

Gently remove the plastic cover that is covering the camera.

Use Phillips # 1 screw to open the four 5mm Philips screws on the motherboard.

Use the plastic opener to remove the battery.

Use tweezers to remove the black tape that is attached to the motherboard.

Detach all the wire that are connected to the motherboard.

Detach the camera module and other components that are attached to the motherboard.

Remove the motherboard with the help of plastic opener.

Use tweezers to hold the power button and gently lift it up.

Replace the old power button with the new one.