Introduction

This guide will show you how to replace the barrel shield spring on the Koosh Vortex Tornado.

Parts

No parts required.

Remove the fourteen 150 mm Phillips #1 screws on the side of the body.
  • Remove the fourteen 150 mm Phillips #1 screws on the side of the body.

Add Comment

Pull the shells apart to show the inside of the gun.  Set the left shell aside.
  • Pull the shells apart to show the inside of the gun. Set the left shell aside.

Add Comment

Using a spudger, unhook the barrel shield's spring from the base of the gun.
  • Using a spudger, unhook the barrel shield's spring from the base of the gun.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jordon Roseman

Member since: 02/16/2016

125 Reputation

1 Guide authored

Team

IUPUI, Team 2-4, Harley Spring 2016 Member of IUPUI, Team 2-4, Harley Spring 2016

IUPUI-HARLEY-S16S2G4

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 69