Introduction

To start, the Front Cover Teardown guide must be used. Later, soldering guides will be used.

Have the camera facing up and the flash closest to you.
  • Have the camera facing up and the flash closest to you.

  • Unscrew the two 6.2 mm Phillips screws on the top half of the camera.

Add Comment

Flip camera to other side-with flash farthest from you.
  • Flip camera to other side-with flash farthest from you.

  • Unscrew top two 6.2mm Phillips screws on this side.

Add Comment

Turn the camera so the bottom is facing up with the front facing away.
  • Turn the camera so the bottom is facing up with the front facing away.

  • Unscrew the 6.2mm Phillips screw on the top right.

  • The front cover is now unscrewed and should be lifted up evenly and removed.

Add Comment

Once the front cover is off, desolder the connections at both ends of the flash.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nick

Member since: 04/26/2011

1 Reputation

1 Guide authored

Team

Cal Poly, Team 25-28, Garner Spring 2011 Member of Cal Poly, Team 25-28, Garner Spring 2011

CPSU-GARNER-S11S25G28

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 5

All Time: 1,410