Introduction

The back panel protects the internal components of the blender.

  1. Remove the glass container and place the blender upside down on a solid surface. Remove the four rubber feet using the needle nose pliers. Remove the four #7.5 Phillips 25mm screws that were located underneath the rubber feet using the Phillips #2 screwdriver.
    • Remove the glass container and place the blender upside down on a solid surface.

    • Remove the four rubber feet using the needle nose pliers.

    • Remove the four #7.5 Phillips 25mm screws that were located underneath the rubber feet using the Phillips #2 screwdriver.

  2. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  3. Lift the back panel up, sliding it along the power cord.
    • Lift the back panel up, sliding it along the power cord.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cameron Geehr

Member since: 09/28/2014

709 Reputation

6 Guides authored

Team

Cal Poly, Team 12-5, Forte Fall 2014 Member of Cal Poly, Team 12-5, Forte Fall 2014

CPSU-FORTE-F14S12G5

5 Members

6 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 203