Introduction

There are a few layers that you have to work through to get to the inside of the Kid Galaxy Explorer. There are screws on the top and bottom holding the Kid Galaxy Explorer together so if it is not coming apart do not pry it open; check for more screws.

Parts

No parts required.

Image 1/1:
  • First, completely loosen the 9.6 mm Phillips #2 screw on top. There is a plastic washer that holds the screw to the top cover, so it will not need to be taken out.

Add Comment

Image 1/1:
  • After the screw has been loosened, lift the cover off.

Add Comment

Image 1/1:
  • Completely loosen the 9.6 mm Phillips #2 screw from the battery cover. Once again, there is a plastic washer to hold the screw to the cover.

Add Comment

Image 1/1: Turn the RC car over to reach the six screws on the bottom.
  • After the screw is loosened, lift the battery cover off the top cover to gain access to the batteries.

  • Turn the RC car over to reach the six screws on the bottom.

Add Comment

Image 1/1: (Wheels are removed in this picture to clearly show screw location. They do not need to be removed for this step)
  • Remove the six 11.6 mm Phillips #2 screws on the bottom cover.

  • (Wheels are removed in this picture to clearly show screw location. They do not need to be removed for this step)

Add Comment

Image 1/1:
  • Lift the top Cover off the car.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eric Studstrup

Member since: 09/22/2014

4 Reputation

2 Guides authored

Team

USF Tampa, Team 1-2, Hickman Fall 2014 Member of USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 Members

7 Guides authored

One Comment

As i can see in the last image. There are some wires still connected with the outer cover. Could have shown couple more images how to get them off. Everything else looks great.

Dishant Patel - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 92