1. Remove both 8.0 mm Phillips #1 screws, one for each wheel.
    • Remove both 8.0 mm Phillips #1 screws, one for each wheel.

  2. Remove the wheels by pulling them away from the RC car.
    • Remove the wheels by pulling them away from the RC car.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Make note of where each driving gear cover is placed. They only go in one way.
    • Make note of where each driving gear cover is placed. They only go in one way.

    • Remove the eight 8.0mm Phillips #00 screws, two screws for each wheel.

  5. Pry open the two gear covers on both sides.
    • Pry open the two gear covers on both sides.

  6. Pull the driving gears off the axles by sliding them off the axles and exposing both axles.
    • Pull the driving gears off the axles by sliding them off the axles and exposing both axles.

  7. Slide both axles from the internal axles guides within the car.
    • Slide both axles from the internal axles guides within the car.

    • Reverse the steps to replace the axles.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Rusbell Gonzalez

Member since: 09/17/2014

219 Reputation

5 Guides authored

Team

USF Tampa, Team 1-2, Hickman Fall 2014 Member of USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 Members

7 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 137