Difficulty
Moderate
Steps
3
Time Required
15 - 30 minutes
- Drive Belt 3 steps
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Introduction
Use this guide to replace a worn drive belt in a Kenmore 110 Series Washing Machine.
Parts
No parts required.
-
Lay the washing machine on its back.
-
Using a 5/16" socket wrench, remove both screws from the belt cover.
-
Remove the belt cover from the washer.
-
Using a 1/2" socket, remove the bolt securing the drive pulley.
-
Remove the drive pulley and belt.
I have difficulty to remove the bolt suring the pulley. Is there any tricky to move the bolt?
need to remove shaft off pulley
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Team
Cal Poly, Team 15-43, Forte Fall 2012 Member of Cal Poly, Team 15-43, Forte Fall 2012
CPSU-FORTE-F12S15G43
5 Members
5 Guides authored
One Comment
What would be reason that rinse cycle doesn't spin and it leaks
