Introduction

The carabineer on the JBL Clip 2 is removable. If the carabineer does not work, you will notice that the device will no longer clip on to secure locations. If this is the case the carabineer will have to be replaced. The device will be taken apart and the carabineer will be removed and replaced.

Image 1/1: If your JBL Clip 2 has never been opened this procedure will require moderate amount of force.
  • Begin by removing the front cap of the JBL Clip 2 by using the blue plastic opening tool to get in between the creases.

  • If your JBL Clip 2 has never been opened this procedure will require moderate amount of force.

Add Comment

Image 1/1: If you are not trying to replace the speaker please ignore the two middle 3 mm T8 screws during this procedure.
  • There will be six 3 mm T8 screws under the cap, remove these six screws.

  • If you are not trying to replace the speaker please ignore the two middle 3 mm T8 screws during this procedure.

Add Comment

Image 1/1:
  • The front cover will lift open easily and the components will be visible.

Add Comment

Image 1/1: While disconnecting be sure to not use too much force as these two parts are meant to become disconnected.
  • To completely remove the top portion, disconnect the speaker from the motherboard using the blue plastic opening tool.

  • While disconnecting be sure to not use too much force as these two parts are meant to become disconnected.

Add Comment

Image 1/1:
  • There will be four 3 mm T8 screws holding the motherboard in place, remove these four screws.

Add Comment

Image 1/1: Be careful not to disconnect any soldered wires connected to the motherboard and speaker casing.
  • Slightly move the motherboard to the side to reveal the sides of battery, carefully using the blue plastic opening tool, remove the battery from the speaker casing.

  • Be careful not to disconnect any soldered wires connected to the motherboard and speaker casing.

Add Comment

Image 1/1:
  • There are two 3 mm T8 screws holding the carabineer in place, remove these two screws.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Michael Hong

Member since: 02/01/2017

681 Reputation

5 Guides authored

Team

UW Tacoma, Team 2-2, Rose Winter 2017 Member of UW Tacoma, Team 2-2, Rose Winter 2017

UWT-ROSE-W17S2G2

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 5

Past 7 Days: 28

Past 30 Days: 87

All Time: 205