Parts

No parts required.

  1. Push in the plastic tab that can be seen through cracks in the front left corner using a spudger. Push in the plastic tab that can be seen through cracks in the front left corner using a spudger.
    • Push in the plastic tab that can be seen through cracks in the front left corner using a spudger.

  2. Move down the same side and push in the plastic tab.
    • Move down the same side and push in the plastic tab.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Move to the front right side and once again push in the plastic tab.
    • Move to the front right side and once again push in the plastic tab.

    • There is not a fourth tab to push in after this one.

  5. Grab the cover by the front side and pull upwards. You might encounter some resistance. Pull firmly, but don't yank it.
    • Grab the cover by the front side and pull upwards.

      • You might encounter some resistance. Pull firmly, but don't yank it.

  6. Tilt the front case down until the pegs detach from the bottom of the case. Lift up and outward.
    • Tilt the front case down until the pegs detach from the bottom of the case.

    • Lift up and outward.

    • The motherboard will be loose at this point.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Chris Rudolph

Member since: 10/05/2010

55 Reputation

1 Guide authored

Team

Cal Poly, Team 7-53, Amido Fall 2010 Member of Cal Poly, Team 7-53, Amido Fall 2010

CPSU-AMIDO-F10S7G53

4 Members

3 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 14

All Time: 3,110