Introduction

Be the envy of onlooking gamers with a shiny new rear bezel on your DSi XL.

Image 1/3: Image 2/3: Image 3/3:
  • Use a push pin to remove the four plastic screw covers on the front bezel.

Add Comment

Image 1/1:
  • Remove four Phillips screws securing the front bezel to the rear bezel.

Add Comment

Image 1/2: The rear bezel will move only about 2 mm. Image 2/2: The rear bezel will move only about 2 mm.
  • Using two hands, gently slide the rear bezel upwards.

  • The rear bezel will move only about 2 mm.

Add Comment

Image 1/2: Rotate the spudger away from the DSi XL, prying the two bezels apart. Image 2/2: Rotate the spudger away from the DSi XL, prying the two bezels apart.
  • Insert a spudger into the gap between the front and rear bezel

  • Rotate the spudger away from the DSi XL, prying the two bezels apart.

Add Comment

Image 1/1:
  • In the same manner as described above, continue prying along the top edge of the front and rear bezels.

Add Comment

Image 1/1: Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.
  • Separate the rear bezel from the front bezel.

  • Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.

Add Comment

Image 1/1: Remove the rear bezel.
  • Use the flat end of a spudger to pry the rear camera off the rear bezel.

  • Remove the rear bezel.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Matt Newsom

Member since: 01/05/2010

27,956 Reputation

67 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 6

All Time: 4,114