Introduction

Does your device not turn on or does the power run out quickly? It is probably the result of a dysfunctional battery. This guide will show you how to remove your battery for a replacement. Be aware that this guide has some steps that can possibly damage the device.

Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.
  • Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.

Add Comment

Detach the back cover by carefully pulling up and out on the back plastic casing. Do not pull apart the red wire connecting the battery to the device.
  • Detach the back cover by carefully pulling up and out on the back plastic casing.

  • Do not pull apart the red wire connecting the battery to the device.

Add Comment

Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.
  • Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.

  • Be careful to not tear the wires while opening the case.

Add Comment

Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.
  • Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.

  • Do not disconnect wires from plastic connector.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

David Poltorak

Member since: 04/18/2013

4 Reputation

1 Guide authored

Team

Cal Poly, Team 12-36, Amido Spring 2013 Member of Cal Poly, Team 12-36, Amido Spring 2013

CPSU-AMIDO-S13S12G36

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 6

All Time: 787