Skip to main content

Shop the Holiday Gift Guide
Free Shipping on Domestic Orders $75+

Infinity v2 10.1 Camera Replacement

Views: 548

View statistics:

Past 24 Hours:
1
Past 7 Days:
17
Past 30 Days:
58
All Time:
548
Comments: 0

No one has left comments on this guide. Will you be first?

Go to guide comments
Completed: 1

1 person has marked this guide "completed." Will you be next?

Favorites: 0

No one has favorited (and subscribed to) this guide. Will you be the first?

Time Required: 10 minutes
Difficulty: Easy
Infinity v2 10.1 Camera Replacement

Introduction

Go to step 1 ↓

The Infinity v2 10.1 camera should be replaced when it no longer turns on, the lens is cracked or water damaged, or when it takes a distorted image. Replacing the camera is a simple process, without any previous repair experience required. You will simply disconnect the camera from the motherboard, which you can do using your fingers. All you will need is a tool to open the device and a new camera to replace with the old one.

What you need

Tools

    1. Infinity v2 10.1 Camera Replacement, Back Case: step 1, image 1 of 3 Infinity v2 10.1 Camera Replacement, Back Case: step 1, image 2 of 3 Infinity v2 10.1 Camera Replacement, Back Case: step 1, image 3 of 3
      • Slightly pry open one corner of the device by using your finger nail to separate the screen from the back case.

      • Use an opening tool to carefully detach the back case from the tablet. Start by inserting the tool where your fingernail opened a gap, and work around all four sides of the device.

      • There will be a slight click noise as you free each tab.

      • Once the case is completely free, carefully lift it and place it face up on the workstation, being cautious not to damage the speaker wires connecting the two halves.

      Ask FixBot

      Add Comment

    2. Infinity v2 10.1 Camera Replacement: step 2, image 1 of 2 Infinity v2 10.1 Camera Replacement: step 2, image 2 of 2
      • Remove the speakers from the case by gently lifting them up and out of their slots.

      Ask FixBot

      Add Comment

    1. Infinity v2 10.1 Camera Replacement, Camera: step 3, image 1 of 1
      • Use your thumb or opening tool to lift the black connector holding in the ribbon cable.

      Ask FixBot

      Add Comment

    2. Infinity v2 10.1 Camera Replacement: step 4, image 1 of 1
      • Remove the camera by gently picking it up and pulling it free from the connector.

      • Avoid touching the lens of either camera.

      Ask FixBot

      Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

One other person completed this guide.

Author

with

sammytarbokas

Member since: 10/31/19

193 Reputation

2 Guides authored

Team

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 17

Past 30 Days: 58

All Time: 548